Conair SC-5 - Manual (Page 94)

Open the flywheel clear guard window.
Remove the cutter head by loosening the Trantorque
assembly. Refer to the manufacturer's guide included with
this User Guide for information about the Trantorque
assembly.
Locate the four bolts holding the motor/reducer
assembly to the cutter. Remove them and carefully
remove the assembly from the cutter.
Refer to the Micron installation and maintenance
information included with this User Guide to check and
adjust the motor/reducer assembly. Refer to section 5,
Installation and Removal Instructions for B-Loc.
6-16
T
ROUBLESHOOTING SC-5 SURE CUT Servo Knife Cutter UGE059/1003
C
HECKING THE
M
OTOR
/
REDUCER
A
SSEMBLY
1
3
2
4