Conair SC-5 - Manual (Page 9)

H
OW TO
U
SE
THE
L
OCKOUT
D
EVICE
UGE059/1003 SC-5 SURE CUT Servo Knife Cutter
I
NTRODUCTION
1-5
WARNING: Electrical hazard
Before performing maintenance or repairs on
this product, disconnect and lock out electrical
power sources to prevent injury from unexpect-
ed energization or start-up. A lockable device
has been provided to isolate this product from
potentially hazardous electricity.
Lockout is the preferred method of isolating machines or
equipment from energy sources. Your Conair product is
equipped with the lockout device pictured below. To use the
lockout device:
Stop or turn off the equipment. Do not stop the
cutter by turning off the disconnect. Always touch the off
soft key on the interface first.
Isolate the equipment from
electrical power.
Turn the rotary disconnect switch to
OFF or O position.
Secure the device with an
assigned lock or tag.
The equipment is now locked
out.
CAUTION: Moving parts
Before removing lockout devices and returning
switches to the ON position, make sure that all
personnel are clear of the machine, tools have
been removed and all safety guards are rein-
stalled.
3
4
O
1
2