Conair SC-5 - Manual (Page 71)

● Weekly
❒ ❒ Cleaning the blade lubrication tray (if the cutter
has this
option). See Cleaning the Blade Tray,
Section 5.
❒
❒ Lubricating shafts on optional slide rail system
See Cleaning the Blade Tray, Section 5.
● Monthly
❒ ❒ Checking hardware on the knife guard
Inspect the hardware on the knife guard (fasteners on
hinge and the clear blade guard window). Tighten as
needed.
❒ ❒ Checking bushing holder proximity switches
Inspect the sets screws which retain the bushing holder
proximity switches for tightness. Adjust as needed. See
Adjusting the Proximity Switches, Section 5.
❒ ❒ Checking the draw latch
Inspect the latch on knife guard windows for wear and
P
REVENTATIVE
M
AINTENANCE
S
CHEDULE
C
ONTINUED
UGE059/1003 SC-5 SURE CUT Servo Knife Cutter
M
AINTENANCE
5-5
❒ ❒ Clean the clear blade guard window
Clean using glass cleaner or plain water. Other materi-
als may cause premature loss of clarity or crazing.
● Semi-annual (every 6 months)
❒ ❒ Inspecting electrical terminals
Check all electrical terminals for tightness; adjust as
needed. See Checking Electrical Connections, Section
5.
❒ ❒ Checking torque on Trantorque coupling device
Check the tightness (torque) of the Trantorque coupling
device with a torque gauge. This device connects the
cutter head to the Micron reducer shaft. See Checking
Torque, Section 5.
❒ ❒ Checking all electrical cables
Inspect all electrical cables for cuts and abrasions.
Replace as needed.
❒ ❒ Inspecting control panel lights
Check to make sure no LEDs or lights are burned out
on the control panel. Replace as needed.
Draw Latch
Clear Guard Windows