Conair SC-5 - Manual (Page 63)

UGE059/1003 SC-5 SURE CUT Servo Knife Cutter
Press the manual cut button and observe the
movement of the cutter blade. The cutter head makes a
single rotation and the blade moves through the cutter
bushings without interference.
Insert a piece of extrudate through the cut-
ter bushings.
Press the manual cut button. A single cut is made
at the preset blade speed. (This works even if Cut On/Off
is off.)
Inspect the cut. If necessary, adjust the blade design
or blade speed. See All About Cutter Blades, Appendix B.
O
PERATION
4-29
C
HECKING
C
UT
Q
UALITY
4
3
2
1
If you have not already done so, check the cutter hardware,
power up the cutter, select cutting mode and blade speed, and
make a test cut to check cut quality.
When you are satisfied with cut quality, press the Cut On/Off
soft key and on is displayed, automatic operation begins.
When the extrudate is running within tolerance, cut it with a
knife or saw and feed it through the cutter bushings.
S
TARTING THE
SC-5 C
UTTER