Conair SC-5 - Manual (Page 26)

3-6
I NSTALLATION
Open the servo cutter’s electrical
enclosure.
Turn the disconnect dial on
the door to the OFF or O position and
open the door.
Insert the main power wire through the knockout
in the side of the enclosure. Secure the wire with a rubber
compression fitting or strain relief.
Connect the power wires to the terminals indicated
on the wiring diagram that came with your machine.
1
2
IMPORTANT: Always refer to
the wiring diagrams that
came with your servo cutter
before making electrical con-
nections. The diagrams show
the minimum size main power
cable required for your cutter,
and the most accurate electri-
cal component information.
C
ONNECTING
THE
M
AIN
P
OWER
S
OURCE
3
WARNING: Electrical hazard
Before performing any work on this product, dis-
connect and lock out electrical power sources
to prevent injury from unexpected energization
or start-up. A lockable device has been provid-
ed to isolate this product from potentially haz-
ardous electricity.
WARNING: Improper installation, oper-
ation, or servicing may result in
equipment damage or personal injury.
This equipment should only be installed, adjust-
ed, and serviced by qualified technical person-
nel who are familiar with the construction, oper-
ation, and potential hazards of this type of
machine.
All wiring, disconnects, and fuses should be
installed by qualified electrical technicians in
accordance with electrical codes in your region.
Always maintain a safe ground. Do not operate
the equipment at power levels other than what
is specified on the machine serial tag and data
plate.
SC-5 SURE CUT Servo Knife Cutter UGE059/1003
Check every terminal screw to make sure wires are
secure. Gently tug each wire. If a wire is loose, use a
screwdriver to tighten the terminal.
Connect the ground wire to either grounding point
shown in the diagram.
4
5