Conair SC-5 - Manual (Page 85)

UGE059/1003 SC-5 SURE CUT Servo Knife Cutter
T
ROUBLESHOOTING
6-7
Symptom
◆
Blade speed does
not change when new
speed is entered into
the control.
◆
Cutter mode selec-
tion does not change
cut mode.
◆
The park (home)
position is drifting,
i.e. the blade parks
further away from
the original park site.
Possible cause
There is a communication
failure between the con-
trol and drive.
There is a communication
failure between the con-
trol and drive.
The coupling between the
servo motor and the
Micron reducer has
slipped.
The Trantorque coupling
has slipped.
Solution
Check for wiring for loose
connections and tighten.
Check for wiring for loose
connections and tighten.
See Checking the Motor/
reducer assembly, Section 6.
Refer to the Trantorque
instructions, Section 5.
E
LECTRICAL
P
ROBLEMS
C
ONTINUED