Conair SC-5 - Manual (Page 87)

UGE059/1003 SC-5 SURE CUT Servo Knife Cutter
T
ROUBLESHOOTING
6-9
Symptom
◆
Burrs at cut site.
Possible cause
The bushings are not pro-
viding enough support
during cutting.
The bushing gap is too
wide.
The blade speed is too
low.
Solution
Change bushing design to
make them more supportive.
The bushing gap should be no
more than .001-.003 inch larg-
er than the blade. Check and
adjust if necessary.
Low blade speeds can cause
excessive blade interruption.
Increase blade speed or
decrease the blade cut path
area.
P
RODUCT
Q
UALITY
P
ROBLEMS
C
ONTINUED