Panasonic SC-CH7 - Manual (Page 46)

I
Tape to Tape Recording
2 1 3 4
0ECK1
ОСХЛУМЯ REV(№
О Ф
StEAEO DOUBLE C iSSETTE 0Е» RS-CH7
COUWTEB мест :0 SYNCH* > START
EDiT-pJ
DECK 2
I Ш I
To record from deck 1 to deck 2
The recording level of the original (playback) tape, and №e
noise-reduction effect on the original tape, will be recorded to the
new tape just as they were in the original recording.
Carry out the steps 1 and 2 of “Recording” on page 40.
1 Insert the blank tape Into deck 2 and the
pre-recorded tape into deck 1.
Be sure to load the tape in decks 1 and 2 with the fonward side
uppermost (so that the “PLAY ►" indicator light),
2 Select the desired reverse mode.
; Single sided recording (forward side only)
: Two-sided recording
(forward side reverse side)
In case the length of a tape set in the deck 2 is longer
than a tape in the deck 1 tne deck 1 repeats the
playback until the deck 2 complete the two-sided
recording, (up to eight times)
(forward side reverse side)
3 Press the edit speed button to select the
recording speed “xl” or *‘x2”.
xl: Normal speed
x2: High speed
4 Press the synchro-start button to start edit-
recording.
The tape edit indicator on the cassette deck will illuminate.
When edit-reoording is completed, the cassette deck automatically
creates a non-recorded passage of about four second in length,
and then enters the recording standby mode.
Note:
Be sure to press the edit speed button to go out of the edit speed
indicator after finishing recording.
To stop edit-recordlng
Press the stop button.
If the ded(
1 operating indicator is tit, press the deck 1/ dedt 2
selector to select deck 2 before stop recording.
If you press the stop button while the deck 1 indicator is lit, the
cassette deck automatically creates a non-recorded passage of
about four seconds in length, and then enters the recording
standby state. Pressing the synchro-start button can resunre
edit-recording.
■ To change the direction of tape travel
1 ) Press the one of the desired play button.
2 ) Press the stop button.
■ While edit-recording Is taking place
You can press one of the input selector buttons on the amplifier
and enjoy listening to another music source, such as a CD.
You can cheunge the settings of the volume and tone controls of the
amplifier without affectirvg the recording.
Note:
Switch off your television set or video equipment when performing
edit-recording at high speed (x2). The reason for this is that noise
is sometimes picked up and recorded.
-46-