1 press the band select button to select the, Desired band *‘mw” or “lw’’), 3 press the memory button momentarily – Panasonic SC-CH7 User Manual
Page 32: Select the desired “channel, 5 press the memory button momentarily, Fm mode (fm auto, mono) memory
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Memory Presettings
(continued)
3 * 5 4
1
Stations can be freely preset to any desired channel.
A maximum of 28 broadcast stations can be memorized.
Carry out the steps 1 and 2 of "Standard Operations” on page
20
.
1 Press the band select button to select the
desired band
*‘MW” or “LW’’).
2 Press the appropriate tuning button to tune to
the desired broadcast.
(Refer to "Frequency tuning" on page 31.)
3 Press the memory button momentarily.
(The memory indicator will illuminate.)
/
auto
CH.
Note:
If the memory button is pressed continuously, the automatic
memory presetting is activated. To stop the automatic
memory presetting, press the tuning button.
Then t^in again from step 2.
Select the desired “channel”
(Refer to "To confirm the stations which are preset to each
channel" on page 31.)
5 Press the memory button momentarily.
(The memory indicator will go out.)
6 Repeat the above procedures to make mem
ory presettings.
■ FM mode (FM AUTO, MONO) memory
With this unit, it is possible to enter into the memory FM broadcast
stations in the nfronaural mode. This is convenient when entering
into the memory an FM broadcast station that Is broadcasting FM
stereo signals in whi^ there is much noise.
(T) Follow above steps 1 through 2.
(g) Press the FM mode button to select “MONO". (The “MONO"
FM mode indicator will illuminate.)
@ Follow steps 3 through 5 above.
ooooo
òóóòt^
tìàùss
P_OQ--
sSt5
V.»
-32-