Panasonic SC-CH7 - Manual (Page 45)

To record another disc on the tape left ATLS (Automatic Tape Level Setting)
(Auto link)
When recording of the first disc has finished, the iink indicator
iiluminates and tracks of another disc can be recorded.
1 Switch the disc to another when recording of
the first disc has finished.
Tracks to be recorded on the tape ieft will be automatically
calculated and displayed.
2 Press the piay button to start recording.
After the recording level has been automatically adjusted, the
recording will start.
Notes:
•If there is not enough space at the end of the tape, it may not be
able to record on the tape left.
•In case you record more than third discs, follow the above
procedures.
•After finishing recording the first disc using the sequencial editing,
tracks to be recorded on the tape will not be displayed, but it is
posable to record another disc.
or the programmed tracks.
When the peak point is found, the peak signal will be sent for about
6 seconds, and the recording level will be set automatically at the
cassette deck. (During this interval, the peak sound will not be
OUt^HJt.)
-45-