To connect two single-line telephone jacks (rj11c), Setup – Panasonic 2-LINE PLAIN PAPER FAX KX-FPW111 User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setup
To connect two single-line telephone jacks (RJ11C)
A. Connect the 2-wire telephone line cord
with TRANSPARENT plugs to L2 jack on
the unit and connect to a single line
telephone jack {RJ11C).
B. Connect the 4-wire telephone line cord
with GREEN plugs to L1/L2 jack on the
unit and connect to a single line telephone
jack(RJHC).
Single line
LINE 1
telephone jack
(RJ11C)
0
- o-
4-wire telephone
line cord with
GREEN plugs
Line surge \
protector /
Single line
telephone jack
(RJ11C)
LINE 2
0
Ferrite core
(For the fax
machine)
- O -
GREEN plug
(
Line surge \
protector /
2-wire telephone
line cord with
TRANSPARENT
plugs
Stopper
TRANSPARENT plug
Remove the stopper with your
finger before connecting the
cord to the L2 jack.
• If you connect the unit to a private branch exchange, connect as follows:
A. Connect the 4-wire telephone line cord to “L2” jack
B. Connect the 2-wire telephone line cord to “L1/L2” jack.
If you use the unit only as a single-line telephone/facsimile
A.
B.
Connect the 2-wire telephone line cord
with TRANSPARENT plugs to L1/L2 jack
on the unit.
Connect to a single line telephone jack
(RJ11C).
Single line
telephone jack
(RJ11C)
c?
(
Line surge \
protector /
2-wire telephone
line cord with
TRANSPARENT
plugs
A ---------------
TRANSPARENT plug
Note:
• If you use the unit as a single-tine telephone/facsimile, set the line usage selection (p. 34).
26