Panasonic KX TGA420B - Manual (Page 57)

storing the Pager Display Number
After storing one of the unit’s phone numbers, you can check that pager
number is stored correctly This phone number will be displayed on your
pager if the message is received from an area which does not provide a
caller ID service or a caller requests not to show his/her information
To check the stored pager
number and pager display
number
1 Press I FUNCTION I
2 Select
“Pager setting”
by
pressing v or a , and press ►
3 Select
“Calling pager”
by
pressing v or A, and press ►
4 Press I DIGITAL SP-PHONEI
• The pager number is dialed
• The pager beeps, and displays the
pager display number followed by
“11”* If not, store the pager
number and pager display number
again
J Press I FUNCTION I
2 Press V or A until the arrow
points to
“Pager setting”,
and press ►
3 Press V or A until the arrow
points to
“Pager display #”,
and press ►
• “Enter display #” is displayed
• If the number has already been
stored, It will be displayed
4 Enter the phone number, up to
11 digits
Enter display #
22233344440
ENTER=Save
• If you misdiat, press ICLEARl
Digits are erased from the right To
erase all the digits, press and hold
ICLEARl
Press I ENTER]
• A beep sounds
• To return to the standby mode,
press fE)^
' Other users can let you know when
they want you to call back, by
following the procedure above
*What “11” means
When your unit alerts your pager after
receiving a message in the mailbox,
“1 r will be displayed after the caller’s
telephone number
(ft
(A
For assistance, please call 1-800-211-PANA(7262)
57