Panasonic KX-F280C - Manual (Page 40)

Selecting the number of rings to answer in the ANS/FAX mode
When in the ANS/FAX mode, the unit will automatically answer on the first ring when receiving a
call.
If you wish to change the number of rings to answer a call, you can choose among the following:
0: Toll Saver (see page 2-13)
1: The unit answers on the first ring (default).
2: The unit answers on the second ring.
3: The unit answers on the third ring.
4: The unit answers on the fourth ring.
The unit will not ring. (RINGER OFF)
HELPFUL HINTS:
• If you wish to have the opportunity to pick up the handset before the call is answered by the unit,
set the number of rings to “3” or “4".
• If you find there is difficulty in fax receiving from machines that have an automatic transmission
feature, set the number of rings to “1".
•To confirm from the remote phone whether a new incoming message has been recorded or not
(see pages 5-23 to 5-28), select the Toll Saver position. This will save you the toll charge for the
call.
To change the ANS/FAX RING COUNT, proceed as follows:
Press the MENU button until the following is shown.
3
[ 1 ] [«■<: 2] [pEF 3]
^CHI 4 ] I JKL 5 I (
MHO
6 I
[ w g 7 ] [ t u v S ] [ * » ' ' 9 ]
[
-X-] [ tf]
PROGRAM[1.DATE 2.TEL
3.SYSTEM 4.REPORT]
Press #, then press 05.
ANS/FAX RING
COUNT=1
[0-4, *]
Press the number of the selection you desire.
Setting selections are:
0: Toll Saver
1: one ring
2; two rings
3: three rings
4: four rings
*: Ringer Off
Press the SET button to store your selection in
memory.
PROGRAM[1.DATE 2.TEL
3.SYSTEM 4.REPORT]
2-12