3 main board, 4 power board, 5 printhead – Panasonic KX-P1150 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

KX-P1150

Screws

Opening Screws Printhead

4.3 Main Board

1. Unplug connector (CN200) on Main Board.

2. Remove the screws (5) from the Main Board.

The Main Board can now be removed.

4.4 Power Board

1. Unplug connector CN1 on the power board.

2. Remove the screws (3) from the power supply

unit.

3. Remove the screws (4) from the enclosure cover.

The enclosure cover, shield plate and power

board can now be separated.

4.5 Printhead

1. Position the carriage at the opening.

2. Remove the screws (2) from the printhead.

3. Release the upper cable cover from the carriage

by pushing down on the upper cable cover at
point (A).

4. Remove the printhead by lifting the printhead and

unplugging the printhead flat cable.

Note: When reinstalling the upper cable cover,

ensure that the print head cable is not pinched

by the cable cover latches.

Note: When the printhead is installed, ensure that

the head gap is correct.

Refer to section 5.1.