Panasonic SC-CH84M - Manual (Page 32)

Use Deck 2 to record the sound being played back on Deck 1.
1
2
DECK 1/2
Press TAPE DECK 1/2.
DECK 1 DECK 2 Prsss ^ OPEN OD both decKs,
^ AOPEM
^ and then insert the tapes.
For playback: Into deck 1
For recording: Into deck 2
Close each deck's holder.
TAPE EDIT
NOR HIGH
Press NOR or HIGH of TAPE
EDIT to start recording.
NOR; Normal speed recording
HIGH: High speed {about 2 times nor­
mal speed) recording.
Recording starts at the selected speed.
Tape travei direction indicator
ddjil T R P E
S U I T
. m
irebuoi
- 4e«
The tape travel direction indicator shows
the tape travel direction of the tape for
recording.
After recording has finished, both decks
will stop.
To stop recording
Press ■.
Both decks will stop.
For your reference
The recording level will be recorded as they are on the tape being
played back.
REV MODE
Press REV MODE to select the
reverse mode.
Single-sided recording
Two-side recording
(forward side-» reverse side)
Same as above (When you press
NOR or HIGH, "cX:)'' will be auto­
matically switched over to
T R P S
~ H0.
^ Press A o r immediately fol-
r lowed by ■.
/'wTVi . This selects which direction the tape runs
XiSS^ / \ r*""./ jn,
b
W l± T R P E
-
► ; Recording from side A
◄ : Recording onto side B
Set both deck 1 and 2 to run in the same
direction, side A.
To switch over between decks 1 and 2
Press TAPE DECK 1/2.
To record onto side B, set deck 2 to run in
the < direction.
•While making a high-speed recording, move visual units such as TV
further away from this unit. It prevents noises from being recorded.
•You cannot record acoustical effects such as bass or changes in
sound quality and field.
32