Panasonic KX-F2781NZ - Manual (Page 55)

Operating the answering device from a remote
phone
(KX>F2781 only)
The following operations are available from a remote location with a touch tone telephone.
Set the unit to the ANS/FAX mode in the AUTO RECEIVE mode before going out (see page 18).
Dial key Remote command Page Dial key Remote command Page
CD
Repeats a message 58 B® Erases all messages 58
S Skips a message 58
BB
Turns on message transfer
/pager call for incoming
messages
59
0
New message playback 57
All message playback 57
00
Turns off message transfer
/pager call for incoming
messages
59
0 Re-records a greeting message 59
0
Stops r'e-recording of a greeting
message 59 0 Skips the greeting message 59
B0 Erases a specific message 58
Remote operation card
You may cut out this remote operation card to use.
Mailbox Remote Operation
Recording a message in a
mailbox:
1. Call your unit.
2. Press g' and the mailbox no.
(0. 0 or [Ti).
3. Leave a message.
Retrieving messages from a
mailbox:
1. Call your unit.
2. Press [*] and the mailbox no.
(m.sor®).
3. Enter the mailbox password
Notice of Remote Operation
4. Press the remote command key
(refer to the reverse side).
•The remote operation is available
only from a touch tone phone when
the unit is in the ANS/FAX mode.
•When the unit is in the TEL mode,
call your unit and wait for 15 rings.
The answering system will
temporarily answer the line. Enter the
remote operation ID during the
greeting message.
The unit will switch to the ANS/FAX
mode.
•When you press any key, press
firmly.
•To send a document, press gg].
When a fax tone is heard, start
transmission.
55