Panasonic PV-C911 - Manual (Page 29)

Repeat Play
Set to see a recording over and over.
1 Press ACTION
to display MAIN MENU.
SELÉCT
SET : ACT ION
1) Press AW< ►
to select “VCR.”
2) Press ACTION
to display SET
UP VCR screen.
SS
'FtOGRAMMINQ
TIME STAMP : ON
SELECT:A »
SET >
END lACnON
1) Press Af to
select “REPEAT
PLAY.”
2) Press ^ to set
REPEAT PLAY
“ON” or “OFF.”
Press ACTION twice
to end setup.
Zero Search
To quickly return to a specific tape counter location.
1 Press DISPLAY during playback
to display the Counter.
beq T n
Press COUNTER
RESET
at the
desired position to
reset to “0:00:00.”
Continue playback, rewind, or
fast forward.
Commercial Skip
By pressing the CM/ZERO button in Playback
mode you can skip over 1 to 3 minutes of
recorded tape in just a few seconds.
1
Press CM/ZERO repeatedly to
select skip time in Play mode.
• No indication appears.
OFF
\
1
St
Press ■
\
2nd Press ■
\
3rd Press-
___)
'1 min Skip
^2 min Skip
'3 min Skip
• Playback repeats when tape end is
reached or unrecorded portion over 30
seconds is detected.
• During playback, you may also press
PLAY/REPEAT repeatedly on the unit to
select REPEAT "ON” or “OFF.”
Press STOP.
1:Z3 45
V T
' I
BEGIN END
Press CM/ZERO
in stop mode to
start ZERO
SEARCH.
• T : Present position mark
V : Zero position mark
• Unit goes into FF or REW mode and
stops at the last point the Counter was
set to 0:00:00.
• If a blank portion exists on the tape, and
depending on the position of the v mark,
the V mark display may be out of position.
• When Zero Search is done in DC mode,
the counter position and the counter and
V mark displays may be out of position.
29