Panasonic PV-C911 - Manual (Page 25)

Cancel a Timer Recording:
(Recording is in progress)
Hold down STOP for a few seconds
to cancel the Timer Recording.
• Any future daily or weekly recordings
will be performed as programmed.
ADD/DLT
SELECT/
SET
^:CH UP
▼:CH DOWN
VOL UP
:VOL DOWN
PROG
STOP
Model PV-C921/PV-C931W
remote is shown here.
Review, Replace or Clear Program
Contents: (Recording is not in progress)
^ Repeat steps 1 and 2 on page 24.
Í e TOiÜOÍflí': OOp tis
it> '8;^ 9:0QP to
4-SÓ .9:0^10:0!^ L
CÁ»CEL;Á0e/DLt
SfLEpt i-Bj*
ÉhiD ■ ÍPBOG/ a CTIOÍ í
Press
AT
to select
the desired program.
RfcrsU/ STÁRT. ! J '
8 SAT 9 : 00 P 12 : 00 A 08
To Replace program...
1 ) Press ► to display.
2) Press
AT
to select
and press ^ or ^
to set new program
contents.
3) Press PROG
(or ACTION)
i E l E ct T a T í F
SÉT ■ ■
ENS> ;PHOSíAtíTÍON
To Clear program...
P DT START $T0P SP6
Press ADD/DLT.
2 B:;iQ:Qppi'2;0G!ii?5.-5P
3 10 8;00p 3;OOp i& SP
4'SO < 0;O0p1O:Dt^, - L LP
SELECT Í-8:* t-
ENTER
6NP íPflOG/ACÍTIíW
4 Press PROG twice (or ACTION) to exit
this mode.
ámm
• 2 minutes before Timer recording is performed,
“PLEASE PREPARE FOR TIMER REC” appears
and/or the PROG TIMER Indicator flashes.
Be sure a cassette with record tab is loaded and the
unit is in Stop mode.
• If the start times of two programs overiap, the lower
numbered program will have priority.
• If the start time for a Timer Recording comes up
during a normal recording or One Touch Recording
(page 14), the Timer Recording will not be performed.
• If there is a power interruption of more than one minute,
the recording may not be performed or continued.
• If “INCOMPLETE” appears after all items have been
set, check all entries and make necessary corrections.
• When using DC Po\wer suf^ly, a Timer Recording can
not be performed if POWER on the unit is pressed OFF.
25