Panasonic DMC-LC43A - Manual (Page 11)

Charging the Batteries
1 Insert batteries into the charger.
2 Connect the AC Mains Lead to the
charger and AC mains socket.
• The AC Mains Lead does not fit entirely
into the socket. A gap wiil remain as
shown ©.
• The charge lamp ® lights and charge
starts.
Preparation
\ Charge is completed when the charge
lamp is no longer illuminated.
• Charging takes in about 5 hours.
Confirm that batteries are inserted properly.
Disconnect the charger from the electrical
outlet after the charging is completed.
I Environment/charge error
Charge in a place with a surrounding
temperature of 0-40°C (also temperature
of the battery).
When charging starts, the charge lamp
tights.
If after charging starts the charge lamp
blinks, it indicates a charge error.
In this case, remove the charger from the
electrical outlet, take out batteries, check
whether the surrounding temperature or the
batteries are too hot or cold, and charge
again. An error cannot be cancelled by
turning the power off/on. If after charging
again the charge lamp still blinks, consult
your nearest servicenter.
► Use Panasonic AA Ni-MH (nickel-metal
hydride) Batteries.
1 1