Panasonic SC-CH64M - Manual (Page 5)

B
accessories
Please check and identify the supplied ac­
cessories.
□
AC mains lead .........................................................1 pc.
(For United Kingdom:
(For Australia and
VJA0733) New Zealand: RJA0036-K)
I I FM indoor antenna ..
(For United Kingdom:
RSA0007)
□
.................................... 1 pc.
(For Australia and
New Zealand: RSA0006)
AM loop antenna set (RSA0010)
•AM loop antenna.....................................................1 pc.
•AM antenna holder ................................................ 1 pc.
•Screw...................................................................... 1 pc.
.. 1 pc. i 1 Remote control transmitter
(EUR644340)
□ Notebook-like binder ...
[Liner notes organizer]
(RFA0622-K1)
I 1 Adhesive number
(RQLA0321)
2 pcs.
. 1 pc.
1 pc.
[ j Antenna plug adaptor.............................................
(Supplied for United Kingdom only: SJP9009)
1 pc.
Use numbers indicated in parentheses when asking for replacement
parts.
Concerning the remote
control
Battery installation
Insert the batteries with this unit as shown below.
Use two UM-3 “AA", lEC R6 (1.5 V) or equivalent batteries.
• Do not mix old and new batteries, or batteries of different types
(manganese and alkaline, etc.).
•Never subject batteries to excessive heat or flame; do not attempt
to disassemble them; and be sure they are not short-circuited.
• If the remote control is not to be used for a long period of time,
remove the batteries and store them in a cool, dark place.
•Do not attempt to recharge alkaline or manganese batteries.
•Do not use rechargeable type batteries.
Battery life
The battery life is about one year.
The batteries should be replaced if commands from the remote
control transmitter do not operate the unit even when the transmitter
is held close to the front panel.
Correct method of use
Remote control
sensor
Transmission
window
Operations notes
About 7 meters in front of
the signal sensor (The
actual range will depend
on the angle at which the
remote control is used.)
•Aim the remote control’s transmission window toward the unit’s
sensor. Avoid any obstacles.
• Be sure the transmission window and the unit’s sensor are free
from dust. Excessive dust might affect its performance.
•The operation may not be correct it direct sunlight or other strong
light source strikes the receiving sensor of this unit. If there is a
problem, place the unit away from the light source.
• If this system is installed in a rack with glass doors, the glass doors'
thickness or color might make it necessary to use the remote
control a shorter distance from the system,
•Never place heavy items,
•Do not disassemble or reconstruct.
• Do not spill water or other liquids.