Panasonic SC-CH64M - Manual (Page 30)

Recording frottiWr^
One-touch editing
> You don’t have to advance the leader tape,
of the reverse mode will be automatically selected.
1
AOPBH ^ Press ^ OPEN, and then in­
sert the tape.
Close the holder.
2
Press CD,
Disc SKIP/
GROUP N/\ME
Press DISC SKIP/GROUP
NAME ( v or a ) to select the
disc you want to record.
/ ■ \
/ TUNWQMQQg \
b
Press
>
and check play starts
and which disc is being re­
corded.
After checking, press ■ and stop play.
CD EDIT Press CD EDIT to start re­
cording.
The deck starts rewinding the tape.
It takes a little while after the button is
pressed for the recording to actually start.
To stop editing:
Press B.
The CD changer also stops.
One-touch editing operation:
1. The cassette deck section will rewind the tape, and then advance
the tape beyond the leader tape while making the non-recorded
passage of about 10 seconds.
2. The recording on side A starts.
3. If the last track on side A has not yet finished recording, that track
will automatically be recorded again from the beginning of side B.
4. Depending on the length of the tape, the last track on side B may
be cut off in the middle.
When one-touch editing finishes:
«The disc and track Nos. last recorded will remain on the display.
• If there is another CD to record, '‘LINK" will flash on the display and
the stereo will automatically start recording the next CD.
• If there isn’t another CD to record, “LINK" will stilt flash on the
display, but the stereo will go on standby. To continue recording,
select a disc and press ►.
To quit linking, press B.
To record programmed tracks:
(i) Perform steps 1-2 on the left of this page, and then press
PROGRAM on the remote control.
(g) Press DISC on the remote control.
<2 ) Select the disc from the remote control with the numeric buttons.
(4) Select the track number from the remote control with the numeric
buttons.
(D Repeat steps until programming all tracks (max. 24 tracks),
(D Perform steps 4-5 on the left of this page.
30