When there is a television set nearby, While listening to ta pes, While listening to compact discs – Panasonic SC-CH64M User Manual
Page 43: While using the remote control
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Problem
Probable cause(s)
Suggested remedy
Reference
page(s)
When there is a television set nearby
The picture on the TV
disappears or stripes
appear on the screen.
The location and orientation of the antenna
are incorrect.
If you are using an indoor antenna, change
to an outdoor antenna,
7
The wiling at the back of the system is
unsuitable.
Separate the antenna wire of the TV set
from the system.
While listening to ta
pes
Sound is low, intermittent,
poor quality, noisy,
scratchy, or unsteady.
Heads are dirty.
Clean the heads.
41
The deck does not enter the
recording mode.
The erase-prevention tabs are removed
from the cassette.
Attach tape to cover the space left by
removal of the erase-prevention tabs.
40
While listening to compact discs
The display does not show
the correct indication. Disc
play does not start when
you press the play button.
The disc label is facing left.
Set the disc with the label facing right.
12
The disc is dirty.
Wipe the disc with a soft cloth.
40
The disc is scratched.
Replace the disc with a new one.
The disc is badly warped.
The disc is a nonstandard one.
Replace the disc with a different one.
40
There is condensation inside the CD
changer.
Switch the power ON, and then wait for
60 minutes before using the CD changer.
The error message “F61"
appears on the display and
the changer stops
operating.
The protection circuitry has functioned
because the positive and negative speaker
connection wires are “shorted".
Turn off the system, and, after determining
and correcting the cause, switch ON the
power once again,
/
/
/
The error message “TAKE
OUT” appears on the
display and the changer
stops operating.
A disc has been put in the slot of the disc in
play.
Remove the disc whose number is
displayed and close the rack panel.
y
y'
/
/
While using the remote control
The system cannot be
operated with the remote
control.
The batteries are installed in the reverse
polarity.
Re-insert the batteries in the correct
polarity.
5
The batteries are run-down.
Replace the batteries with new batteries.
5
When a CD does not return to its slot (“TAKE OUT‘
flashes on the display):
Check whether another disc is in the slot or not. If not, hold down the
■ (stop) button for 4 seconds. The changer will then eject the disc. If
this proves to be ineffective, contact the place of purchase.
43