Using the play timer, Using the record timer – Panasonic SC-CH64M User Manual

Page 32

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Using the play timer

0REC/

®PUY

POWER

STAHDBV

Select the desired source and

then prepare the stereo for

play.

When you play CD(s):
Press CD and insert CD(s).
Stop the CD(s) after playing.
When you play a tape:

Press TAPE and insert a tape.
Stop the tape deck after you select the
direction of the tape.
When you play the radio:

Press TUNER BAND and tune in the de

sired station.
When you play a unit connected to the
“AUX" terminals:

Press AUX.

Set the playback volume.

Press © REC/0 PLAY.

Your selections and setting will be stored
in the timer’s memory,

Confirm "© PLAY" lights on the display.

Press POWER to put your ste
reo on standby.

The timer play will start at the preset time
with volume increasing gradually up to
the volume level you preset.

To switch the timer OFF:

Press © REG/® PLAY and check “0 PLAY" goes out.
The settings made with the preceding procedure will however be kept

in memory.

To check settings (only while power is ON);

Press CLOCK/TIMER 3 times and check "© PLAY" is displayed.

Two seconds later, the display will change in the following order.

@ Play source and playback volume

To change settings (only while power is ON);

Using the timer at the same time setting continu
ously;

(You can accomplish this even if your stereo is on standby.)
Press © REC/© PLAY and check “® PLAY" is displayed.
As long as “® PLAY" is displayed, the timer will work every morning
at the same time.

To enjoy the desired source after the timer setting

is completed:

1. After finishing step 6, start playing the desired source.

Even if you change the volume level or music source, the timer
play will start with the preset condition.

^503
When you set the CD changer for timer playback, playback will

start with the last disc played and in the last playback mode used.

2. Press POWER to standby mode after enjoying the play, and

confirm CD(s) or a tape has (have) been inserted.

• If the power is on, the timer will not function. The system must be in

the standby mode.

•The ON time and OFF time cannot be the same setting.
• If you switch the power to the standby mode while the play timer is

functioning, the OFF time setting will not be activated.

• Play timer cannot be used in combination with the record timer.
•The lowest possible volume with the timer is -60 dB. If you set it

lower than this, it will automatically be played back at -60 dB just
the same.

For your reference

External sources must be connected to the “AUX” terminal. However,

time settings apply only to this stereo. For more information, see the

instruction manual of the connected unit.