Ustening to compact discs, Setting/removing discs, Open the rack panel – Panasonic SC-CH64M User Manual
Page 12: Close gently the rack panel, Slide the loader carriage to the slot you want, Cds playback modes, Listening to compact discs, Setting/removing discs cds playback modes, How to set discs, How to remove discs
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Ustening to compact discs
Setting/Removing discs
Special notes
• You can set discs in the rack and remove them too, while playing
discs.
• Never set a disc in the slot of the disc being played.
•Sometimes the rack panel cannot be opened while a disc is playing,
It is a question of time, in such case, wait until you can open it.
• Do not open the rack panel while the changer is changing discs.
How to set discs
1. Open the rack panel.
changer while open. You could injure yourself if somehow entangled
in the internal mechanism.
2. Slide the loader carriage to the slot you want.
You can read the numbers between the prongs
3. Set the disc on the loader and flip the loader
upwards.
Label side
12
• Do not use 8 cm discs fitted with expander rings. Use the 8 cm
discs as they are, to prevent damage to the slots from rings.
• Do not use cleaning discs, discs with stickers on the label side or
warped discs. Alt of these could damage your changer.
• Do not put anything other than discs in the changer.
•Do not set a disc in the slot of the disc being played (slot flashes).
The disc in play is returned to its slot when finished. If the two discs
somehow jam the slot, one or both could be damaged. When this
happens, the message “TAKE OUT’ will appear on the display.
Remove the disc that doesn’t belong in the slot and close the rack
panel.
• Set discs with the label facing to the right.
• Never load more than one disc in any given slot.
4. Close gently the rack panel.
You will hear a catching sound when the rack panel closes.
How to remove discs
1. Open the rack panel.
2. Slide the loader carriage to the slot you want.
3. Press the eject button gently on the loader car
riage.
usa
When removing CDs while the power is on, make sure the source is
set to “CD" before removing CDs.
If you cannot remove the disc:
1. Press CD.
2. Open the rack panel.
3. Slide the loader carriage to the slot of the disc you want to
remove.
4. Press the eject button.
How to know what disc in what slot
Your changer comes with a notebook-tike binder (liner notes orga
nizer) in which you can keep your CD liners. There are also adhesive
numbers for indicating slot numbers in the binder. This is a conve
nient way to keep track of what disc is in what slot.
Put two liners back-to-back inside each pocket, as shown above.
Do not put CD cases in the binder.
CDs playback modes
With this CD changer, you can playback CDs in the following
2 modes.
• Block mode...Normal sequential playback (page 13).
• Group mode...Only CDs registered in the selected group are
played back (page 15),