Panasonic SC-CH64M - Manual (Page 18)

Usteningtoc^
Program play
by remote control only
Everyone has his/her favorite tracks. You can program the changer
to play them in a specific order. With this changer, you can make one
program and fill it with up to 24 selections from any of the discs in the
rack.
This example shows how to program track 8 of disc 2.
Press CD.
1
2
CD
PROGRAM
(In the stop mode)
Press PROGRAM.
Í J J J ^ «y úP. D ISC
gSora
7 Fhn] NoO
Press DISC.
PP
H I S C
r f?“ 0 N o G
4
ciSOcii
ÓÓ(±)
While is flashing (approx. 10 seconds)
Select the disc(s) you want
with the numeric buttons.
For example:
To select disc 2, press 2.
Specified disc number
JJJ^ ^ ^ MCU
H I S C ¿
N o D ' W
You can select slot No. 0.
“SINGLE" appears on the display.
cí5c!jKÍ3
cbcí:tcb
Press the numeric button(s) to
specify the track.
Program order
TÍ?'“G N o
Specified track number
6
7
Repeat steps 3 to 5 until you
have completed all entries.
Press ^/11 to start play.
Play will start and tracks will be played in
the programmed order. When all tracks
have been played, play will stop automat­
ically.
Selecting double-digit discs and tracks numbers:
First press >10. and then press the numbers for the two digits.
For example: number 20
Press yo, then 2, and than 0.
To cancel program play mode:
(In the stop mode)
Press PROGRAM.
The changer will return to the sequential play mode.
The programmed contents will remain stored in memory until they
are cleared, even after the program mode is canceled.
Therefore, after programming, it is possible to cancel the program
mode and use another play mode and then hear the same program
again at a later time.
In addition, if discs are changed, the program will be played using the
new discs. If non-existing entries are found at this time, the changer
will cancel them.
For your reference
The program will remain stored in memory for approximately 2 weeks
even after the system is switched oft.
18