Panasonic SC-CH64M - Manual (Page 26)

WHveriientfmctìù
Your attention is drawn to the fact that recording pre-recorded
tapes or discs or other published or broadcast materia! may
infringe copyright laws.
Type of tape which can be recorded
correctly
The unit automatically identifies the type of tape.
NORMAL POSITION/TYPE I O
HIGH POSITION/TYPE II X
METAL POSITION/TYPE IV X
Recording may not turn out as you want it to when using HIGH
position and METAL position tapes.
To mute the volume
bv remotG control only
This feature is convenient when you have a telephone call, etc.
MUTING P t 6 ss MUTING-
How to advance the leader tape
Wind the leader tape forward so that recording can start as soon as
you press the button. But, this is not necessary if edit-recording from
CDs.
The leader tape is the first few revolutions that you cannot record on.
M
J R P e " " _ Magnetic section
Vi U T I N G S ““
(on which sound can be recorded)
Press the button again to cancel.
“MUTING” goes out.
Muting can also be canceled by lowering
the volume alt the way (— dB).
When the system is turned off, the muting
operation will be automatically canceled.
Demo function
This stereo comes with a “demo” function. The default setting is for
the demo function to be ON.
Switching the demo function on or off:
Press and hold -V.BASS/-DEMO for
-V.BAS8 about 2 seconds or more.
-DEMO
& c? 5
H E M O
OFF
When the demo function is set to on:
•When the power is ON;
When the input source is set to “CD" or “TAPE", the demo function
wiil run automatically after about
2 minutes or more pass in the stop
mode.
You can turn the demo function OFF any time by pressing ► or ■.
•When the system is in the power standby mode:
When you do not set the time, the demo function runs automa­
tically.
26
Leader tape
(on which sound cannot be recorded)
Concerning the volume level while
recording
The deck automatically sets the recording level. If you change the
volume level while recording, it does not affect the recording volume
level.
Concerning the sound quality and field
while recording
While recording, none of the changes you make to sound quality or
field will affect recording.
While recording, “FLAT' is temporarily selected no matter what
sound quality and field settings you selected. When finished record­
ing, the stereo will revert back to your settings.
I'ggna
You cannot open the cassette holder while recording.
To erase a recorded sound
1. Press TAPE,
2. Insert the recorded tape into deck.
3. Press REV MODE to select reverse mode,
4. Press REC START/STOP.