Cleaning and replacing the air fi, Cleaning the air filter – Panasonic TC-LT1 Series User Manual

Page 34

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Cleaning and Replacing the Air Fi

Dust build-up in the air filter will raise the internal temperature of the Projector, whereupon the Temperature Monitor will flash on

and off and the power will be turned off. Please clean the air filter without fail If the Temperature Monitor flashes on and off.
Cleaning the Air Filter is indicated approximately every 100 hours of use, although requirements will differ depending on the
location in which the Projector is used.

Cleaning the Air Filter

Preparation

Turn off the Main Power on the Projector, and unplug the power cord.

Please be sure to follow the instructions on page 11 (Turning Power On and Off)

Remove the outer cover (on the bottom of the Projector).

Remove the Filter Unit

Filter Unit (Milk White Colour)

Use a vacuum cleaner to remove dust.

Place the vacuum cleaner hose on
the filter and hold in one location

for several seconds. Repeat this
over the entire filter.

*Do not attach a brush.

• Do not remove the filter from the filter unit.
• Do not place the filter surface in direct contact with hard objects. This may damage the fitter. Do not

continue to use the filter if it should become damaged.

• Do not rub the filter with the vacuum cleaner hose. This may damage the filter.
• Even if all black soot cannot be removed from the filter, this will not affect performance.