Operating panel on the side of the projector, Remote control, Replacing the lamp unit – Panasonic TC-LT1 Series User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Replacing the Lamp Unit
e
Insert the power plug into the socket, and turn on the Main Power on the front panel of the Projector.
• If the power does not turn on even though the Main Power switch has been turned on, turn the
Main Power back off, and confirm that the Lamp Unit and the Lamp Unit Bay Cover are firmly in
place. Then turn the power back on.
Press the power button on the operating panel on the side of the Projector, or on the remote control, and begin
picture projection.
©
To Turn Off Lamp Monitor Display
Operating Panel on the Side of the Projector
Remote Control
0 AV/RGB Switching Button on the Remote Control
Press the above three buttons at the same time.
Remote Control
r
The 3 lamps on the Projector will flash on and off for 5 seconds, after which the Lamp Monitor Display will turn
off, completing the replacement procedure.
•3 lamps
33