Panasonic TC-LT1 Series - Manual (Page 21)

The picture can be adjusted to your preference for each AV/RGB setting selected for the projector using the method discussed on
p. 20 (adjustments will be stored for each of Pictures 1 through 3). The options that can be selected will differ between the Video
(S-Video) signal and the RGB signal. The adjustment procedures presented below are explained on the screen when inputting the
Video (S-Video) signals.
Adjusting the Picture to Your Preference
o
Press the MENU Button.
Select the “PICTURE” menu with the
buttons.
Set with the < and ► buttons.
and
PICTURE
COLOUR SYSTEM
SETTING
FEATURES
UNGUAGE
@
Press the remote control “PICTURE MENU"
button, and select the picture menu you want
to adjust.
Select the “COLOUR” with the 4 and ► buttons.
o
@
Press the 4 and ► buttons to adjust.
PICTURE 1
COLOUR
32
NTSC-TINT 32
BRIGHT 32
CONTRAST 63
SHARPNESS 32
COLOUR TEMP STD
PICTURE 1
COLOUR
NTSC-TINT
BRIGHT
CONTRAST
SHARPNESS
32
32
32
63
32
COLOUR TEMP STD
COLOUR
35 H
Press the "N"
button to
return to the
normalisation
setting.
Press the "MENU" Button twice to complete
(screen returns to the normal viewing condition).
• The buttons you press and the adjustments made will differ depending on the adjustment setting. Please refer to
the following table.
Adjustment
Item
Button Adjustment
Extent of
Adjustment
Remarks
COLOUR
► Increases the Colour
Maximum
Value 63
Of^ operational during video
signal input (including S-Video). 4
Lightens the Colour
Minimum
Value 0
NTSC-TINT
► Adds a Green Tint to Flesh Tones
Maximum
Value 63
Only operational during
NTSC3.58/NTSC 4.43 video signal
^(including S-Video).
4
Adds a Purplish Red Tint to Flesh Tones
Minimum
Value 0
BRIGHT
► Brightens the picture
Maximum
Value 63
4
Makes the picture darker
Minimum
Value 0
CONTRAST
► Makes the screen brighter and the picture darker
Maximum
Value 63
4
Makes the screen darker and the picture brighter
Minimum
Value 0
SHARPNESS
► Increases the sharpness of the picture quality
Maximum
Value 63 Only operational during video
sigrial input (Induding S-Video).
4
Makes the picture quality softer
Minimum
Value 0
COLOUR TEMP 4>
STD -Standard
Warm-Adds a reddish hue to the screen.
Cool-Adds a bluish hue to the screen.
• Press the “MENU” Button to close the Adjustment Screen or Main Menu Screen.
• NTSC tint can not be adjusted for the colour systems SECAM and PAL.
• The selected colour temperature can be stored in the memory, however, it would be the same even if the input is
switched over.
21