BendixKing KLX 135 - Pilots Guide - Manual (Page 95)

4.14.3. VIEWING THE KLX 135 SOFTWARE STATUS AND TIME
OF OPERATION
The OTH 5 page (figure 4-207) shows
the software revision status of the
KLX 135 host computer (line 1) and of
the GPS receiver (line 2). Line 3
displays the total number of hours of
operation and line 4 displays the
number of times the unit has been
turned on. These values are reset to zero if the KLX 135’s non-
volatile memory is cleared.
4.15. REMOTE MOUNTED ANNUNCIATORS
The KLX 135 has outputs capable of driving two
remote annunciator lights: waypoint alert and
message. Although these annunciators are optional,
it is desirable to have them mounted in the pilot’s
normal scan area so that these annunciators are
easily seen. A typical annunciator is shown in figure
4-208; however, actual annunciation abbreviations
and configurations may be different.
The remote waypoint alert annunciator is on whenever waypoint
alerting is occurring. See
sections 4.8.3 , “Waypoint Alerting for Direct
To Operation” and 4.10.2 , “Turn Anticipation and Waypoint Alerting”.
The remote message annunciator is on whenever the message
prompt is on. See
section 4.5 .
Basic GPS Operation
4-64 Effective Date 3/94 006-08751-0000 Rev 0
Basic GPS Operation
Chapter 4
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
118.00 Host SW 01
136.97 Rcvr SW 01
>Leg Tot Hours 115
OTH 5 Pwr Cycls 67
Figure 4-207
Figure 4-208
WPT
MSG