BendixKing KLX 135 - Pilots Guide - Manual (Page 90)

To set the time on the SET 2 page:
1. Select the SET 2 page if it is not already selected.
2. Turn on the cursor and move it to
the time zone field (figure 4-190).
3. Change the time zone with the
right inner knob, if desired
(figure 4-191). A listing of the
time zones and their abbrevia-
tions is contained in
section 4.2 ,
“Turn-on and Self Test”.
4. Move the cursor to the time field.
The hours and minutes will
appear in inverse video.
5. Select the correct hour
(figure 4-192). Remember, the
KLX 135 uses 24 hour time. If it
is 1:00 P.M. or later, add 12
hours (for example, 2:30 P.M.
becomes 14:30).
6. Move the flashing part of the
cursor to the tens of minutes,
select the proper number
(figure 4-193), then move on to
the last digit and set it.
7. Press
F
to start the clock
running (figure 4-194). Note that
the seconds will reset to zero
when you do this.
KLX 135 Pilot’s Guide Basic GPS Operation
4-59 Effective Date 3/94 006-08751-0000 Rev 0
Basic GPS Operation
Chapter 4
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
118.00 DATE/TIME
136.97 08 DEC 94
>Leg 1536:30
MST
CRSR Mountain Std
Figure 4-190
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
118.00 DATE/TIME
136.97 08 DEC 94
>Leg 1536:31
MDT
CRSR Mountain Day
Figure 4-191
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
118.00 DATE/TIME
136.97 08 DEC 94
#>Leg
14__ :42 MDT
CRSR Mountain Day
Figure 4-192
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
118.00 DATE/TIME
136.97 08 DEC 94
#>Leg
143_ :42 MDT
CRSR Mountain Day
Figure 4-193
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
118.00 DATE/TIME
136.97 08 DEC 94
>Leg 1430:00
MDT
CRSR Mountain Day
Figure 4-194