BendixKing KLX 135 - Pilots Guide - Manual (Page 108)

KLX 135 Pilot’s Guide Advanced GPS Operation
5-13 Effective Date 6/95 006-08751-0000 Rev 1
Advanced GPS Operation
Chapter 5
2. Press D a second time. The
annunciation DIRECT TO
changes to ACTIVATE
(figure 5-44). Repeated presses
of
D
cause the annunciation to
alternate between DIRECT TO
and ACTIVATE. Make sure ACTIVATE is displayed.
3. If the desired waypoint is not the one that was suggested by the
KLX 135, enter the desired identifier. Press
F
.
4. Press
F
to approve the
waypoint page and activate the
waypoint (figure 5-45). The
selected course does not
change, therefore this method
does not center the D-Bar like a
Direct To operation does.
5.4.OPERATION OUTSIDE THE PRIMARY COVERAGE AREA
The KLX 135's primary coverage area is from N 74° to S 60° as was
shown in
figure 4-1 . Navigation outside this area is automatically
referenced to true North unless a manual input of magnetic variation
is made on the SET 2 page. The same is true anytime the KLX 135
is in the OBS mode and the active waypoint is outside the primary
coverage area. Under both of these conditions, the following
message will be displayed on the Message page:
*Magnetic Var Invalid
All Data Referenced
To True North
When navigation is within the primary
coverage area, the SET 2 page does
not display magnetic variation
(figure 5-46). However, under the
conditions stated above, a user
magnetic variation may be entered on
line 4 of the SET 2 page.
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
118.00 DATE/TIME
136.97 25 DEC 94
>Leg 1830:09 EST
SET 2 Eastern Std
Figure 5-46
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
122.90 ACTIVATE:
123.12
#>149
ARG
CRSR
Figure 5-44
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
122.90 ∆GQE
123.12 > ««««“‘∫««««
>149 50.1nm 109kt
NAV 1 >148°To 0:28
Figure 5-45