BendixKing KLX 135 - Pilots Guide - Manual (Page 61)

Basic GPS Operation
4-30 Effective Date 3/94 006-08751-0000 Rev 0
Basic GPS Operation
Chapter 4
To fly Direct To a waypoint (procedure 2):
1. Select the desired waypoint page
(APT, VOR, NDB, or SUP) on the
screen (figure 4-93) using one of
the three procedures explained in
section 4.8 .
2. Press
D
. The Direct To page is
displayed and it contains the
desired waypoint identifier
(figure 4-94).
3. Press
F
. The display will revert
to the NAV 1 page with the
selected waypoint as the Direct To waypoint.
If you get off course and wish to recenter the left/right deviation bar
(D-Bar) to proceed to the same waypoint, use the following
procedure:
To recenter the D-Bar by going direct to the active waypoint:
1. Select a non-waypoint page (NAV, FPL, CAL, SET, or OTH) on
the screen.
2. Press
D
. The Direct To page is displayed on the left, contain-
ing the active waypoint identifier.
3. Press
F
.
4.8.2. CANCELING A DIRECT TO
To cancel Direct To operation:
The primary reason for wanting to cancel Direct To operation is to
return to flight plan operation which is described later in
section
4.10.4 “Combining Direct To and Flight Plan Operation”.
1. Press
D
.
2. Press
E
to blank out the way-
point identifier field (figure 4-95).
3. Press F .
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
118.00 JJC 396
136.97 MOUNT A IN CITY
>Leg N 36°24.99'
CRSR W 81°49.46'
Figure 4-93
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
118.00 DIRECT TO:
136.97
#>Leg
JJC
CRSR
Figure 4-94
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
118.00 DIRECT TO:
136.97
>Leg
_____
CRSR
Figure 4-95