Talkaphone ETP-402V Dual Button Emergency / Information Phone - Manual (Page 4)

Hardware Installation
4. Connect the Green wire to Earth Ground.
5. Your phone has one auxiliary input and two auxiliary outputs. The auxiliary
outputs are rated at a maximum of 50 mA at 30V DC or AC.
a. The Brown and Blue wires are the auxiliary input.
b. The Red and White wires are auxiliary output #1.
c. The Orange and Black wires are auxiliary output #2.
If your wires do not match these color combinations, you may have a different generation
of phone. See section A. Indoor Emergency Phones above for the correct combination
of AUX wires.
To use the auxiliary input feature, contact Talk-A-Phone to request an ETP-AUXIN-KIT
at no charge. This is not required for models ETP-400-MOD2 or ETP-400V-MOD2.
If the AUX ports are not used, tape off the AUX leads to prevent shorting.
6. Place the phone into the saddle bracket or ETP-SME and secure it with the four
#10 spanner screws. The saddle bracket is not used if installing ETP-SME
Surface Mount Extension.
C. 400 Series Outdoor Flush Mount Phones
Talk-A-Phone offers several mounting accessories for our outdoor flush mounting
phones, ranging from simple back boxes to towers with pan-and-tilt camera domes.
For detailed mounting accessory installation instructions, consult the literature that
accompanies the relevant mounting accessory. Each phone comes with six #10
spanner screws. If you do not own this type of screwdriver or bit, you may purchase
one at your local industrial supply store or from Talk-A-Phone. Contact your
Talk-A-Phone distributor for purchasing information.
1. Plug the RJ11 connector on the cable extending from the unit into an RJ11
receptacle connected to the phone line (red is ring, green is tip).
2. Connect the Green wire to Earth Ground.
3. Your phone has one auxiliary input and two auxiliary outputs. The auxiliary
outputs are rated at a maximum of 50 mA at 30V DC or AC.
a. The Brown and Blue wires are the auxiliary input.
b. The Red and White wires are auxiliary output #1.
c. The Orange and Black wires are auxiliary output #2.
If your wires do not match these color combinations, you may have a different generation
of phone. See section A. Indoor Emergency Phones above for the correct combination
of AUX wires.
To use the auxiliary input feature, contact Talk-A-Phone to request an ETP-AUXIN-KIT
at no charge. This is not required for models ETP-400-MOD2 or ETP-400V-MOD2.
If the AUX ports are not used, tape off the AUX leads to prevent shorting.
4. Place the phone into its mounting accessory and secure with six #10 spanner
screws (included).