Talkaphone ETP-EL12/24 LED Blue Light (12/24V) - Manual

ETP-EL12/24 Installation Instructions
Copyright 2010 Talk-A-Phone Co. All rights reserved.
Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714-3804 Rev. 8/26/10
Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com
Specifications are subject to change without notice.
Talk-A-Phone is a registered trademark of Talk-A-Phone Co.
I. Introduction
Model ETP-EL12/24 is a 12-24VDC/24VAC outdoor-rated combination blue light and strobe. The blue light is lit at
all times to draw attention to the location. The strobe can be activated by Talk-A-Phone emergency phones or by
third party devices that provide a dry contact closure or relay output. ETP-EL12/24 has a low power mode setting
for use in applications where power consumption is an important consideration.
II. Power requirements
ETP-EL12/24: 10-30VDC / 20-28VAC, 7.5 Watts, 1.5 Watts low power steady mode (18A peak inrush)
III. Mounting
If installing the blue light strobe in a Talk-A-Phone phone mount, such as an ETP-MT mounting tower, follow the
instructions included with that mount. Alternatively, remotely mount the blue light strobe to a 4” square conduit
box using an ETP-MBKT mounting bracket. Screws are included with the mount or bracket.
IV. Wiring
The ETP-EL12/24 blue light strobe (polycarbonate base) can be connected to either the 12-24VDC or the 24VAC
output voltage of the power source (shown in Figure 1). The ETP-EL12/24 blue light strobe (aluminum base) can
be connected to either the 12-24VDC or the 24VAC output voltage of the power source, while grounding the white
wire (shown in Figure 2).
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE
APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE
CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS
INVOLVED
CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D’INSTALLATION
PERTINENT, PAR UNE PERSONNE QUI CONNAÎT BIEN LES PRODUIT ET
SON FONCTIONNEMENT AINSI QUE LES RISQUES INHÉRENTS