Talkaphone ETP-PMKT Pole Mounting Kit - Manual

ETP-PMKT Pole Mounting Kit Installation Instructions
Copyright 2009 Talk-A-Phone Co. All rights reserved.
Talk-A-Phone
Co. • 7530 North Natchez Avenue • Niles, Illinois 60714-3804 Rev. 7/27/09
Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com
All prices and specifications are subject to change without notice.
Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.
ETP-PMKT Pole Mounting Kit consists of:
4 3/4" 1-bolt flared leg brackets (includes bracket, bolt and washer)
1 strand of 7’ long 3/4" band
2 3/4" Buckles
Connecting a Talk-A-Phone Surface Mount to a Post
You will need 2 brackets and 1 buckle to mount a surface mount to a post. Keep or discard the extra brackets
and buckle as you wish. For a vertical post, connect one 1-bolt flared leg bracket to each of the pre-drilled holes
above and below the central conduit hole in the back of the surface mount box. Each bracket comes with a bolt
and washer, which are placed through the pre-drilled holes from within the surface mount.
For a horizontal post, connect the brackets to the pre-drilled holes on the right and left of the central conduit hole
in the back of the surface mount box.
Use the enclosed Band and Buckles to fasten the surface mount box to the post. Use the Band-It Tool to fasten
the Bands and Buckles. For details of how to use the Band-It tool, see the instructions that came with your tool.
The tool is available separately as model ETP-PMKT-TOOL.
Surface Mount Box with flared leg bracket attached