Vernier EasyData Guidebook User Manual
Page 52
EasyData Guidebook
51
4. Press
to clear the long sensor name. Type in
the name of the custom sensor, then select
.
Press
to clear the short sensor name. Type in
the short name of the custom sensor, then select
.
Press
to clear the sensor unit. Type in the unit of
measurement for the custom sensor, then select
5.
If the sensor requires a special warm-up period, press
to clear the old warm-up time and type in the
new value, then select
. Note: if you are unsure
about a warm-up time, enter a value of 1.
6.
The Displayed Decimal Places screen is displayed.
Choose the number of decimal places to display sensor
readings, then select
.
7.
From the Sensor Signal Type screen, choose the type
of sensor being set up and then select
. Note:
most sensors are 0-5 Volt.