Cabletron Systems 7C03 - Manual (Page 38)

Using the 7C0x SmartSwitch Hub View
2-22 Monitoring Hub Performance
Viewing the Interface List
You can use the Interface List application to view a complete list of MAC
Addresses assigned to the interfaces installed in your 7C0x SmartSwitch chassis.
To open the Interface List:
1. If necessary, put the Hub View into the Interface Application Display mode
(click either mouse button on the Module Index or Module Type box to display
the Module menu, drag down to Application Display, then across to select
Interface).
2. Click either mouse button on the Display Mode box in the Hub View to launch
the Interface menu; drag down to Interface List, and release. The Interface
List window,
Figure 2-12 , will appear.
Figure 2-12. Interface List Window
The Interface List window displays an IF # for each interface and the MAC
Address
(physical address) associated with each interface. The first two interfaces
are the 7X00 controller module’s interfaces to the 7C0x chassis switching
backplane; note that they share a MAC address. The remaining index numbers are
assigned in an XXXXYY format, where X = slot index times 10,000, and Y = port
index. For example, an interface index of 30017 would be assigned to port 17 on
the module installed in slot 3 of the chassis.