Hit Products LogicPLUS S 42/128 User Manual

Page 20

LogicPLUS-S Two-Wire Controller

note: Program 6 can be sensor activated, such as a temperature sensor. The terminals

for remote operation are located on the terminal board and marked pr6trg (program 6 trig-

ger). Program the amount of run times per valve in program 6, do not put in a start time,

make sure the program is On in position 8 and whether or not the master should run with

program 6.

Program the amount of loop time in position 7. When the remote sensor activates and closes

the contacts for more than 30 seconds, program 6 will operate for the looping time programmed.

If for any reason the remote sensor contact opens during the looping cycle, the looping cycle will

continue until the programmed time is completed. The sensor must open and close the contacts

to operate the looping cycle a second time. If, for any reason, the contacts open and close dur-

ing the pre-programmed length of looping, the looping program will reset at that time and start

over again.

Position 7 | | Looping Program No. 6 | | Function Button- Security Password