Hit Products LogicPLUS S 42/128 - Manual (Page 16)

LogicPLUS-S Two-Wire Controller
16
16
Position 5 | | Total Run Times | |
To review the total run time in a specific program, use set 1 to choose the program number. The total
run time of that specific program is shown in the lower right hand position of the display. You can review
the water budget setting along with the total run time in this position. If the water budget is changed from
the default 100% the total run times will change in this position, but in position 2, the valve run times will
stay inputted. The actual running valve is determined by the input in position 2 multiplied by the water
budget setting in position 8.
note: On a 7 day calendar the actual day will be displayed.
note: By adjusting the budget up or down (0% to 250%) it will change the total run time.
See position 8 for further discussion. The budget is the second leg of the diamond Setting.
Position 5