Hit Products LogicPLUS S 42/128 - Manual (Page 15)

15
LogicPLUS-S Two-Wire Controller 15
Position 4 | | Start Time | |
To set start times, use set 1 to choose the desired program, use set 2 to choose the start number,
always use start 1 for the first start time after midnight and so on through start 8 (LogicPLUS-S 42)
start 16 (LogicPLUS-S 128) use set 3 to set the hour of the start time, use set 4 to set the
minutes of the start time.
note: The start time is part of the first leg of a pre-programmed function called “diamond
Settings” Refer to diamond settings at the end of this programming guide for full details.
Position 4