Welch Allyn Connex CSK 4.1.X - Installation Guide - Manual (Page 16)

12 Installation Welch Allyn Connex CSK software
CP 50, CP 100, CP 150, or CP 200
Before you install the Welch Allyn Connex CSK software do the following:
• If connecting to a CardioPerfect Workstation, do the following:
• Verify that the CardioPerfect Workstation software and database have both been
upgraded to version 1.6.0 or higher. If necessary, upgrade the software and
database now.
• When using a stand-alone CardioPerfect Workstation system, please install the
server software on the stand-alone CardioPerfect Workstation system
• When using a client/server configuration, please install the server software on the
CardioPerfect Workstation database server before installing the clients.
• Verify that the connectivity settings in the software are properly configured. For
details, see the electrocardiograph directions for use.
• If using a CP 200 electrocardiograph in a wireless configuration, do the following.
• Verify that the electrocardiograph software product version is 2.4.0 or later.
• Verify that the Wireless Settings item is available on the Connectivity Settings
menu. If not, a hardware upgrade is needed. Contact your Welch Allyn service
representative.
• Check the electrocardiograph’s network and wireless settings. Verify that these
settings match the access point settings.
For details, see the electrocardiograph directions for use.
• Verify that you have administrator rights for the CardioPerfect Workstation software
and for the PC.
• Close all programs before starting the installation.
• If “Device driver signing” appears, select either “Yes” or “Continue.”