Welch Allyn Modem-Propaq - Quick Reference Guide - Manual (Page 14)

14 Protocol Systems, Inc.
At the New Propaq Location
6. Plug the modem power adapter into the electrical power outlet.
7. Plug the modem telephone cable into the telephone outlet.
8. Turn on the modem.
9. Plug the Modem-Propaq Cable into the Propaq ACUITY-MODEM connector.
Within a few seconds, the modem will automatically dial the Acuity telephone
number. Depending on the phone line quality, the connection may require a
few minutes.
Note
If the modem does not dial and connect to Acuity, unplug and plug in the Modem-Propaq
Cable at the ACUITY-MODEM connector.
At the New Propaq Location or Acuity Central Monitor
10. After connection, the Propaq and Acuity display CONFIRM PATIENT? Do one
of the following:
• Press YES to restore the patient’s name and previous room number.
OR
• If the patient was previously assigned a room number, Acuity and the
Propaq display a
NEW ROOM button. You can press NEW ROOM to restore
only the patient’s name. The Acuity Central Monitor then prompts for a
new room number.
At the Acuity Central Monitor (if a New Room Number is Needed)
11. Type the patient’s new room number into the Patient ID Setup Window.