Welch Allyn AcuityLink Clinician Notifier - User Manual User Manual
Page 53
6
49
Log out of Clinician Notifier to change
units or end your shift
When a device is logged out of the Clinician Notifier program, it does not deliver patient
alarms.
Plan to log out of the Clinician Notifier program in these situations:
•
To enter a period during which you do not want to be notified of patient alarms
•
To recharge the device battery
•
To move to another unit during your shift. Since mobile devices are assigned to only
one unit, you must log in to a new device at the new unit.
•
Before the device is handed over to another clinician (so that the Welch Allyn
Connectivity Server disassociates you from the device)
If you re-log in within two hours, in the same unit, your patients remain assigned to you. If
you log in to a device in a different unit, you must assign patients to yourself, as usual.
To log out of the Clinician Notifier program and recharge the mobile device
1.
If you do not see a Clinician Notifier program window on your mobile device screen,
tap
, and then tap
Clinician Notifier.
A Clinician Notifier screen appears.
2.
Tap
in the upper right corner of any screen.
A confirmation popup window appears.
3.
Tap Yes.
You are logged out of the Clinician Notifier program.
4.
Recharge the device as specified by the device manufacturer.
Note
If
is not visible on your mobile device, perform a soft reset of the device.
For soft reset instructions, see
Note
If an alarm occurs during the logout process, and if the Logging Out popup
recedes, tap
until the Logging Out popup window re-appears.