Welch Allyn AcuityLink Clinician Notifier - User Manual - Manual (Page 37)

Directions for Use View patient information 33
To adjust the Details display
1. Adjust the display.
• To change the lead source or vital-sign source of the waveform: Tap the pulldown
menu, and then tap your selection.
• To change the waveform amplitude: Tap anywhere in the grid.
• To change the waveform sweep speed: Tap mm/sec.
To suspend the patient’s alarm
If the patient is in an alarm state, you can suspend the alarm in this page.
1. Tap Suspend.
The Suspend button changes to Resume. If you want to resume the alarm, tap
Resume.
Notification of all alarms for this patient is suspended for 90 seconds on all mobile
devices that received the alarm. However, new lethal arrhythmia alarms and apnea
alarms for the patient interrupt the suspend state.
Tones are also suspended for this patient at the Acuity Central Station and the patient
monitor.
To view the patient’s realtime waveform
1. Tap Realtime.
The patient’s Realtime page appears.
If Realtime is grayed out, this patient is not connected to the Acuity System.
Alarm type