Cisco 4-Port SSL/IPSec VPN Router RVL200 - Manual (Page 105)

9
Multiple VLANs and Subnets
4-Port SSL/IPSec VPN Router
Appendix M
Subnet Mask Select ...0.
Range Start Enter 00.
Range End Enter 49.
For VLAN3, complete the following:
IP Address Enter 9.8... (This is the default,
which you can overwrite.)
Subnet Mask Select ...0.
Range Start Enter 00.
Range End Enter 49.
For VLAN4, complete the following:
IP Address Enter 9.8.4.. (This is the default,
which you can overwrite.)
Subnet Mask Select ...0.
Range Start Enter 00.
Range End Enter 49.
Click Save Settings.
Inter-VLAN Routing Option
To allow packets to travel from one VLAN to another,
follow these instructions (optional):
Access the web-based utility of the RVL200. (Refer to
“Chapter 4: Advanced Configuration” for details.)
Click the DHCP tab.
Click the Inter-VLAN Routing tab.
Select the VLANs that can route packets to each other:
VLAN, VLAN, VLAN, and/or VLAN4.
DHCP > Inter-VLAN Routing
Click Save Settings.
–
–
–
8.
–
–
–
–
9.
–
–
–
–
10.
1.
2.
3.
4.
5.