Cisco 4-Port SSL/IPSec VPN Router RVL200 - Manual (Page 17)

Chapter 4 Advanced Configuration
9 4-Port SSL/IPSec VPN Router
System Up Time This is the length of time in days, hours,
and minutes that the Router has been active. The current
time and date are also displayed.
Port Statistics
Click any port on the Router’s rear panel image to see the
status of the selected port. If the port is disabled, it will
be red; if enabled, it will be black. If the port is connected,
it will be green. Information about the selected port will
appear in a separate window.
The port’s Summary table shows the settings of the
selected port, including Type, Interface, Link Status, Port
Activity, Priority, Speed Status, Duplex Status, and Auto
negotiation.
Port 1 Information
For the selected port, the statistics table shows this
information: number of packets received, number of
packet bytes received, number of packets transmitted,
number of packet bytes transmitted, and number of
packet errors.
To update the on-screen information, click Refresh. To
exit this screen, click Close.
Network Setting Status
LAN IP It shows the current LAN IP Address of the Router,
as seen by internal users on the network, and it hyperlinks
to the LAN Setting section on the Network screen of the
Setup tab.
WAN IP This shows the current WAN IP address of the
Router, as seen by external users on the Internet and
hyperlinks to the WAN Connection Type settings on the
Network screen of the Setup tab. If the port is set to Obtain
an IP automatically, two buttons, Release and Renew, will
be available. Click Release to release the IP address, and
click Renew to update the DHCP Lease Time or get a new
IP address. If the WAN port is set to PPPoE or PPTP, two
buttons, Connect and Disconnect, will be available.
Mode It shows the Router’s Working Mode (Gateway or
Router), and it hyperlinks to the Dynamic Routing section
on the Advanced Routing screen of the Setup tab.
DNS It shows all DNS Server Addresses and hyperlinks to
the WAN Connection Type settings on the Network screen
of the Setup tab.
DDNS It shows the DDNS settings of the Router’s WAN
port and hyperlinks to the DDNS screen of the Setup tab.
DMZ Host It shows the DMZ Private IP Address and
hyperlinks to the DMZ Host screen of the Setup tab. The
default is Disabled.
Firewall Setting Status
SPI (Stateful Packet Inspection) It shows the status
(On/Off) of the SPI setting and hyperlinks to the General
screen of the Firewall tab.
DoS (Denial of Service) It shows the status (On/Off) of
the DoS setting and hyperlinks to the General screen of
the Firewall tab.
Block WAN Request It shows the status (On/Off) of the
Block WAN Request setting and hyperlinks to the General
screen of the Firewall tab.
Remote Management It shows the status (On/Off) of
the Remote Management setting and hyperlinks to the
General screen of the Firewall tab.
IPSec VPN Setting Status
IPSec VPN Summary It hyperlinks to the Summary screen
of the IPSec VPN tab.
Tunnel(s) Used It shows the number of VPN tunnels
used.
Tunnel(s) Available It shows the number of VPN tunnels
available.
SSL VPN Setting Status
SSL VPN Summary It hyperlinks to the Summary screen
of the SSL VPN tab.
Tunnel(s) Used It shows the number of VPN tunnels
used.
Tunnel(s) Available It shows the number of VPN tunnels
available.
Log Setting Status
It hyperlinks to the System Log screen of the Log tab.