Cisco 4-Port SSL/IPSec VPN Router RVL200 - Manual (Page 43)

Chapter 4 Advanced Configuration
4-Port SSL/IPSec VPN Router
Summary
Tunnel Used The number of VPN tunnels being used is
displayed.
Tunnel Available The number of available VPN tunnels
is displayed.
Tunnel Status
Add New Tunnel Click Add New Tunnel to add a
Gateway-to-Gateway tunnel. The Mode Choose screen
appears.
Mode Choose
Click Add Now to display the Gateway to Gateway screen.
Proceed to the “IPSec VPN > Gateway to Gateway” section
for instructions. Click Return to return to the Summary
screen.
After you have added the VPN tunnel, you will see it listed
in the table.
No. It shows the number of the VPN tunnel.
Name It shows the Tunnel Name that you gave the VPN
tunnel.
Status This indicates the status of the VPN tunnel.
Phase Enc/Auth/Grp This shows the Phase 2
Encryption type (DES/3DES/AES-128/AES-192/AES-256),
Authentication method (MD5/SHA1), and DH Group
number (1/2/5) that you chose in the IPSec Setup section.
Local Group This shows the IP address and subnet mask
of the Local Group.
Remote Group The IP address and subnet mask of the
Remote Group are displayed here.
Remote Gateway It shows the IP address of the Remote
Gateway.
Tunnel Test Click Connect to verify the status of the
VPN tunnel. The test result will be updated in the Status
column. If the tunnel is connected, a Disconnect button
will be available so you can end the connection.
Config. Click Edit to open a new screen where you can
change the tunnel’s settings. Refer to the “Gateway to
Gateway” section for more information. Click the Trash
Can icon to delete all of your tunnel settings for each
individual tunnel.
Tunnel Enabled The number of enabled VPN tunnels is
displayed.
Tunnel Defined The number of defined VPN tunnels is
displayed.
IPSec VPN > Gateway to Gateway
Use this screen to create a new tunnel between two VPN
devices.
IPSec VPN > Gateway to Gateway
Add a New Tunnel
Tunnel No The tunnel number is 1.
Tunnel Name Enter a name for this VPN tunnel, such as
Los Angeles Office, Chicago Branch, or New York Division.
This allows you to identify multiple tunnels and does not
have to match the name used at the other end of the
tunnel.
Enable Check this box to enable a VPN tunnel. (When
you create a VPN tunnel, this check box will be disabled.)
Local Group Setup
Local Security Gateway Type
Select the type you want to use: IP Only, IP + Domain
Name(FQDN) Authentication, IP + E-mail Addr.(USER