Jtag hardware installation, Linux jlink software installation (jlinkgdbserver) – ThingMagic Mercury xPRESS Platform v1.7 User Manual

Page 90

A D I V I S I O N O F T R I M B L E

Using the Developer Toolkit

The Schematic can be found here:

http://microcontrollershop.com/download/ARM-JTAG_20-10-schematic.pdf

and

JTAG Hardware Installation

1. Unplug power from both the SAM-ICE (or other J-Link-based device) and the target

board. While not strictly necessary, it is safest to connect the two while powered
down.

2. Connect the SAM-ICE to the target board with a JTAG cable. Make sure the

connector and cable are oriented as shown below.

3. Plug the SAM-ICE into a USB port on the debug host computer.

4. Power up the target board. (This is most easily done by moving the Always-on jumper

to the “On” position - See the Quick Start Guide.)

5. Activate USB

Ensure that the USB port to the J-Link is active

Linux JLINK Software Installation (JLinkGDBServer)

The following instructions are for installation on a LINUX system. Skip to the next section
if you are using a Windows-based system.