ThingMagic Mercury xPRESS Platform v1.7 - Manual (Page 22)

Hardware Setup
A D I V I S I O N O F T R I M B L E
22 Quick Start Guide
2. Connect the supplied MMCX antenna cable to port 1 of the RFID module. Connect
your antenna to the other end of the cable (though an R-TNC to R-TNC cable if
necessary). Make sure all the antenna cable connections are tight.
3. Make sure the Flash Erase jumper is in the “NORM” position.
4. If you are using a Li-ion battery (not supplied with platform), plug it into the two- or
three-port jack, as appropriate.